Dianne - great review of the Clear Blue Fertiity Monitor! Just last night I was trying to figure out whether there was a difference between the Clear Plan and the Clear Blue.

I do have one question though. I've read that it stores up the info from the previous six months. If I find an old one, is there a way to delete the last woman's info? Can I reset it to what it would have been when it came from the factory? It doesn't seeem to be referred to anywhere in the instructions.

Thanks in advance!

Missy

__________________
Missy

Yes there is here is the way to delete the memory. It does work I have reset mine. I had a few long cycles and it was waiting till CD16 to ask for a stick. When it is reset it will ask on CD6. I really hope this helps. I will also make sure it is posted in one of the sticky post.


READ INSTRUCTIONS BEFORE ATTEMPTING TO RE-SET THE MONITOR!

1. Remove the plastic cap from one end of a clean-unused-test-stick and snap the cap onto the other end of stick. Inset the test stick into the test stick slot of the monitor. The beveled corner on the insertion end of the stick must face in toward the monitor. THE STICK MUST SNAP INTO PLACE TO PERFORM PROPERLY . The monitor should not be turned until step 2.

2. Press and hold the "M" button. Continue pressing the "M" button while turning the monitor on. NOTE: Do not take finger off the "m" button until these directions say to do so in STEP 5.

3. The screen will show the "remove the test stick" symbol (a flashing test stick with an arrow pointing right). Continue pressing "M".

4. Keep pressing the "M" button and in about 20 seconds, you will see a screen full of symbols. The screen will also display these symbols when you initially turn the monitor on for the FIRST time. This indicates the memory is now cleared of all prior data.

5. Remove the test stick first and then QUICKLY release your finger from the "M" button. The memory should now be cleared.

6. Your screen should display a flashing "M" and one or two dashes. If it does not, it will probably show a "1" and an "M" in a non-flashing mode. If so, you will need to repeat all steps of the process. This procedure may take several times before you successfully reset the unit to its “new” state.

7. Start using the monitor on CD 1 as per the instruction booklet. "

When should I give it sticks?

The first cycle, your monitor will ask for a stick beginning on day 6. In the beginning, it’s best to do that. As time goes on and you know your cycle better, you can save sticks by starting a little later. Once you get a peak, you can stop testing. The monitor will automatically give you a peak two days in a row.

How do I read the lines?

This link gives pictures of a typical nonmedicated cycle and what will happen to the lines.
http://users.ekns.net/moorell/cyclex.htm

__________________

Missy

__________________
Missy

U beat me to it Christina .

That certainly is great info for anyone that needs to reset their monitor. This certainly is the place to find out all that information

No probs Missy, about review. So many ppl ask if the CBEFM & the CPEFM r one in the same, so that review certainly clears that ?? up , it is great info for everyone.

__________________

Host of TTC with Fertility Monitors/OPK